<thinking>
To create a SPICE-like netlist for the given circuit, we need to identify each component and its connections:

1. **Resistor R1**: It is connected between nodes 3 and 1. The voltage across it is labeled \( V_0 \).
2. **Voltage Source V1**: It is connected between nodes 1 and 0 (ground). This is the independent voltage source.
3. **Dependent Voltage Source**: It is controlled by \( V_0 \) and has a gain of \( c_1 \). It is connected between nodes 3 and 0.

Based on this analysis, the netlist can be written as follows:

- For the resistor \( R1 \): `R1 3 1`
- For the voltage source \( V1 \): `V1 1 0`
- For the dependent voltage source: `EV0 3 0 1 3 c1`

Note that in SPICE, a dependent voltage source is denoted by 'E', followed by the name, the positive and negative output nodes, the positive and negative control nodes, and the gain value.

</thinking>
<answer>
R1 3 1
V1 1 0
EV0 3 0 1 3 c1
</answer>